showdomainmode(8)
338 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2009
Privileges You must have one of the following privileges to run this command:
Refer to setprivileges(8) for more information.
OPTIONS The following operands are supported:
EXTENDED
DESCRIPTION
â– If the Mode switch of the operator panel is set to Service, the settings of the
modes of operation for the specified domain have the following values,
regardless of the domain mode displayed by the showdomainmode(8) command:
Autoboot Displays the state of the auto boot function. One of the
following is displayed:
on Enabled
off Disabled
CPU Mode Way of determining the CPU operational mode mounted on
the domain. One of the following is displayed.
auto
Automatically determines at domain startup
compatible
Sets to the SPARC64 VI compatible mode regardless of the
CPUs mounted
Ethernet Address XSCF-supplied domain ethernet (mac) address. This is the
address that OpenBoot PROM/Solaris will use when its
configuration parameter local-mac-address? is set to
false. This information will be displayed only if the -v
option is specified.
platadm, fieldeng Can run this command for all domains.
domainadm Can run this command only for your managed domains.
-d domain_id Specifies the domain ID of the domain to be displayed. domain_id
can be 0–23 depending on the system configuration.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-v Displays detailed information. When this option is specified, the
XSCF-supplied domain ethernet (mac) address will also be
displayed.
To Next Page
Loading...
Need help?
General
