showdscp(8)
System Administration 343
NAME showdscp - display the IP addresses assigned to the Domain to Service Processor
Communications Protocol (DSCP)
SYNOPSIS showdscp
showdscp [-v][-p]
showdscp [-v][-p] -d domain_id
showdscp [-v][-p] -s
showdscp -h
DESCRIPTION showdscp(8) displays the IP addresses assigned for DSCP usage, the IP addresses
for an individual domain, the Service Processor, or for the entire system. When
used without options, it displays current IP data.
When displaying IP addresses for all DSCP links in the system, the output is a
table. The table is sorted by numerical domain IDs.
When displaying IP addresses for a particular domain or just the Service Processor,
then the output is not a table but simply the IP address of the specified domain or
Service Processor.
The -p option can be used to generate parsable output that would then be suitable
for use in a script. Parsable displays of individual IP addresses exclude any
additional labels, and only an IPv4 address in dotted-decimal form is output. The
parsable version of tabular output includes only the values (no table headings are
included), and each column is separated by a single tab character.
Privileges You must have one of the following privileges to run this command:
fieldeng, platadm, platop:
Can display any DSCP IP information.
domainadm, domainmgr, domainop:
Can display individual IP addresses for domains for which you have privileges
only.
Refer to setprivileges(8) for more information.
To Next Page
Loading...
Need help?
General
