Preparing your Sunbeam Caffe Bellissimo continued
Close the door with the coffee dispensing
unit.
Place a carton of cold milk (5 - 8°C) into
the milk box to the left of the coffee
machine.
Insert the milk tube into the open milk
container.
Note: The slanted tube end must reach the
bottom of the milk container.
Using the milk box
Preparing the cold packs:
Remove the screw plug and rubber
stoppers of the cold pack.
Fill the cold pack with water.
Note: Do not fill the cold pack to the brim to
avoid bursting during freezing
Put the cold pack into the freezer.
Installing the milk box:
Place the milk box to the left of the coffee
machine. Open the lid and put previously
cooled cold packs into the holder.
Insert a milk carton.
Insert the milk tube into the open milk
carton. See Figure 7.
The slanted tube end must reach the
bottom of the milk container.
Put the tube into the recess on the upper
edge and close the lid.
Note: The milk box is supplied with two cold
packs. These can both be used to keep the
milk cold for up to 3 hours. For optimum
results, return milk to the fridge immediately
after use. This will result in the best froth
quality.
Filling with water
Caution: Milk, mineral water or other liquids
can damage the water tank or the coffee
machine.
Only fill the water tank with fresh, cold
water.
Observe the maximum filling level of 1.4
litres.
To ensure a quality coffee, change the water
in the water reservoir daily and wash the
reservoir at least once a week in hot soapy
water and rinse thoroughly.
11
To Next Page
Loading...
