EasyManua.ls Logo

Sunbeam EM9300 Caffe Bellissimo - Page 14

Sunbeam EM9300 Caffe Bellissimo
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preparing your Sunbeam Caffe Bellissimo continued
Push the coffee dispensing unit upwards to
its highest position.
Press the water tank and pull it out of the
coffee machine. See Figure 8.
Figure 8
Fill the water tank with fresh water up to
its maximum marking shown on the right
hand side of the tank. See Figure 9.
Replace the water tank. Push it until it
clicks in. See Figure 10.
Figure 10
12
If the following warning appears on the
display, the water tank must be refilled
before the next coffee is dispensed.
Prior to switching on each time, make sure
there is water in the water reservoir and
replenish if necessary. As the machine
requires water for the automatic rinsing cycle
every time the machine is switched on and
off.
Important: Only operate the machine when the
waste container and drip tray are fitted.
Switching on the coffee machine
Before switching on, always check that the
water tank and the coffee bean container
are full. If necessary, top up with water or
coffee beans. Every time the coffee machine
is switched on or off, it requires water for the
automatic rinsing cycle.
A cup can be placed under the coffee
dispensing unit during the rinsing process to
avoid the drip tray filling too quickly.
Press the ON/OFF button Tto switch on
the coffee machine. During the heating up
process (approximately 45 seconds), the
following appears on the display:

Related product manuals