12
Item Name
Quantity
I Foot 4
J M5*14 hex socket screw 7 ~ 18
K
Expansion plug set
2
L M5 screw sets 3~6
M M6 fender washer 2~4
N
Stud（optional）
1
O SUNCLIX Connector 1
P OT terminal 1
Q Documents 1
* Images are for reference only. The actual products received may differ.
* If the top cover is C1, you will received M5*125 hex socket screws. If the top cover is C2,
you will receive stud.
Please refer to the installation diagram for the specific quantity of fasteners used.
3.3 Storage
Proper storage is required if the battery is not installed immediately.
• Store the battery in the original packing case with the desiccant inside.
• Preferably, keep the temperature in the range of 15℃ to 25℃. Store the battery within
the temperature range of -10℃ to 35℃ for no more than 6 months.
• The storage relative humidity must be always between 0 and 95%, non-condensing.
• Store the battery in a clean and dry place, without exposure to sunlight and rain. The
storage location must be free of harmful gases, flammable/explosive products and corro-
sive chemicals. The battery should be prevented from mechanical impact, high pressure,
high-intensity magnetic field and direct exposure to sunlight.
• Pay attention to the harsh environment, such as sudden cooling/heating and collision, to
avoid damage to the battery.
• The number of stacking layers of battery modules with package must not exceed 6. It is
strictly forbidden to directly stack batteries without package.
• Regularly inspect the package for damage and insect bites. If any damage is found, the
product should be replaced immediately.
• The packing should be upright.
• If stored for more than 6 months under the specified conditions, the battery needs to be
charged once, until the system SOC is 50% to 80%. Preferably, use an PCS for forced
charging.
Store the battery for no more than three years; otherwise, over 20% of the ca-
pacity may lose irreversibly.
3 Unpacking and Storage User Manual
To Next Page
Loading...
