22
4.3 Storage
If it is not to be installed immediately upon reception, the PCS should be stored
appropriately.
• Store the PCS indoors, for example, large warehouse or workshop, to prevent possible
condensation or damp;
Raise the PCS base if it must be stored outdoors due to site conditions. The specific
height should be reasonably determined based on site geological and ambient
conditions. When the ambient temperature is too low, heat the PCS internal devices.
• The storage temperature should be between -40℃ and +70℃, and the relative humidity
should be between 0 and 100% without condensation.
Store the PCS on a dry, clean and solid ground with sufficient carrying capacity. The
ground should be flat without water, bumps or vegetation cover.
• Lock the doors of internal devices and the PCS during storage.
• Take effective measures to protect the air inlets and outlets of the PCS, and to prevent
water and dust from penetrating into the PCS.
Check the PCS and internal devices at least once every half a month.
4 Delivery and Storage System Manual
To Next Page
Loading...
Need help?
General