Sungrow SG8K3-D - Installing the Inverter

User Manual 4 Mechanical Mounting
23
Torx screwdriver
TX30
Socket wrench
Open end: 10mm (for M6
bolts)
13mm (for M8 bolts)
16mm (for M10 bolts)
4.4 Installing the Inverter
Inverter is installed on the wall by means of wall-mounting bracket and the
expansion plug sets.
The expansion plug set shown below is recommended for the installation. They
are not included in the delivery scope.
Stainless steel screw M6 Spring washerFender washerExpansion tube
1. Align the wall mounting bracket
horizontally on the wall with the
arrow upwards. M
ark the
position of the drill holes. Use
at least one hole on the right-
and left-hand side of the wall
mounting bracket.
Tip: When mounting on a post,
use the upper and lower central
holes of the wall mounting
bracket.
2. Set the wall mounting bracket aside and drill the marked holes. The
depth of the holes should be about 70 mm. Install the wall-mounting
bracket.