Home
SunStar
Sewing Machine
SPS/B-1306 SERIES
SunStar SPS/B-1306 SERIES User Manual
4
of 1
of 1 rating
61 pages
Give review
Manual
Specs
To Next Page
To Next Page
To Previous Page
To Previous Page
Loading...
45
8
8
SPS/B(A)-1306(1507)-GS-10
1)
Machine Specifications
It is the same as the specification of SPS/B(A)-1306(1507)-HS-10
2)
How to Thread the Upper Thread
After placing the thread take-up at the highest position thread the thread as indicated in the picture below.
Thread the thread as shown in picture A for the needle bar thread guide.
Picture A
44
46
Table of Contents
Default Chapter
4
Table of Contents
4
Machine Safety Regulations
6
Machine Transportation
6
Machine Installation
6
Machine Repair
6
Machine Operation
7
Devices for Safety
7
Caution Mark Position
8
Contents of Marks
8
Specifications of the Machine
9
Structure of the Machine
10
Names of each Parts of the Machine
10
Inside Structure of Control Box
11
Installation of the Machine
13
Environment for Machine Installation
13
Electric Installment Conditions
13
How to Install the Table Safety
13
The Assembly of Peripheral Parts
17
Preparations before Operating the Machine
20
How to Supply Oil
20
How to Install the Needle Bar
21
How to Thread the Upper Thread
22
Threading the Lower Thread
22
How to Take the Bobbin Case on and off
23
How to Adjust the Tension of the Upper Thread and the Lower Thread
23
How to Wind the Lower Thread
24
Adjusting the Height of the Presser Foot
24
Disposing the Waste Oil
24
Model of Transformer by Voltage and Setup of Voltage
25
Caution When Using the Floppy Disks
26
How to Repair the Machine
27
Adjusting the Height of the Needle Bar
27
Adjusting the Needle and the Shuttle
27
Adjusting the Lower Shaft Gear and the Rocking Shaft Gear
28
Adjusting the Spring on the Upper Side of the Shuttle
28
Adjusting the Height of the Feed Plate
29
Adjusting the Presser Foot Devices
29
Adjusting the Parts for the Presser Plate
31
Adjusting the Parts for Thread Release
31
Adjusting the Parts for the Wiper
33
Adjusting the X-Y Parts
34
Adjusting the Trimming Parts
35
Adjusting the Main Thread Control Device
38
Adjusting the Upper Thread Detecting Device
38
Adjusting the Hand Pulley Device
38
Adjusting the Winding Device
39
How to Set the Position of Syncro (a Series)
39
Mounting the Direct Motor and Adjusting Method (B Series)
40
How to Set the Original Point of X-Y
41
Exchanging the Fuse
42
Causes of Break-Down and Throubleshooting
43
Troubleshooting
43
Sps/B(A)-1306(1507
45
Machine Specifications
45
How to Thread the Upper Thread
45
Sps/B(A)-1306(1507)-Hp(Gp)
46
Machine Specifications
46
How to Attach the Needle
47
How to Hook the Upper Thread
47
How to Hook the Lower Thread
47
Adjusting the Spring on the Upper Side of the Shuttle
48
Adjusting the Moving Knife and the Fixed Knife
48
SPS/B(A)-1306(1507)-HS(GS)-20(21, 22-1, 22, 23) and SPS/B(A)-1310-HS
49
Machine Specifications
49
How to Attach the Parts for Air Pressure Control
50
How to Adjust the Air Pressure
50
Attaching the Pressure Plate Sheet and Adjusting the Height of the Slider Base
50
How to Adjust the up and down Movement of the Upper Feed Plate
51
How to Use the Manual Pedal Switch
52
Air System Ciruit Diagrams
54
Setting and Adjustment of SPS/B(A)-1310
58
Drawing of Table
60
4
Based on 1 rating
Ask a question
Give review
Questions and Answers:
Need help?
Do you have a question about the SunStar SPS/B-1306 SERIES and is the answer not in the manual?
Ask a question
SunStar SPS/B-1306 SERIES Specifications
General
Brand
SunStar
Model
SPS/B-1306 SERIES
Category
Sewing Machine
Language
English
Related product manuals
SunStar SPS/B-1811 SERIES
57 pages
SunStar SPS/B-1507 SERIES
61 pages
SunStar SPS/E-BH6100
75 pages
SunStar SPS/E-BS1201H
49 pages
SunStar SPS/D-BH6000-02
62 pages
SunStar SPS/D(C)-B1202-02
39 pages
SunStar SPS/D(C)-B1202-03
39 pages
SunStar SPS/C-B1201 SERIES
59 pages
SunStar SPS/ D-B1254 Series
44 pages
SunStar SPS/E-BS1202 Series
38 pages
SunStar SPS/D-BH-6000 Series
62 pages
SunStar SPS/A-Pattern Series
195 pages