Page | 14
SUNSYNK MAX | User Manual
Risk of injury (Heavy Object)
Remember that this inverter is heavy so users must be careful in handling the unit
during installation especially when mounting or removing from a wall.
Choose the recommend drill head(as shown in below pic) to drill 4 holes on the wall, 52-60mm
deep.
1. Use a proper hammer to fit the expansion bolt into the holes.
2. Carry the inverter and holding it, make sure the hanger aim at the expansion bolt,fix the
inverter on the wall.
3. Fasten the screw head of the expansion bolt to finish the mountng.
To Next Page
Loading...
Need help?
General