SunSynk SYNK-8K-SG04LP3 - Page 44

THREE PHASE HI 8~12kW | Installer Manual44
Therefore, if a communication error occurs:
1. Check that your data cable is the correct type.
2. Check that the data cable is plugged into the correct sockets. Usually, RS485 is employed, but some
battery manufacturers use others.
NOTE:
With some types of lithium batteries, the BMS cannot be controlled by the Sunsynk inverter. In this
case, treat the battery as a lead-acid type and set the charging and discharging protocol following the
battery manufacturer's specications.
It is crucial to refer to the manuals that manufacturers produce for their batteries. That way, the chance of
errors occurring during installation is signicantly reduced. Below is a list of batteries that have been exam-
ined, tested, and approved by Sunsynk.
Brand Model
48V
Storage
Inverter
RS485
or CAN
Inverter
Setup
Notes
DYNESS
B4850

CAN
0
POWERBOXF 0
A48100 0
SunketESS LFP5000

CAN 0
Osily LFP5KWH/LV

CAN 0
HUBBLE
AM-2 5.5KW

CAN 0
AM-5 CAN 0
CANH = Pin 4
CANL = Pin 5
AM-10 CAN 0
SACRED SUN
SSIF2P15S48100C

RS485 1
Cut Line 3, 6, 8FCIFP48100A RS485 1
SSIFP48100A RS485 1
SHOTO SDC-Box5(5.12KWH)

CAN 0