SWL2820 Operator’s Manual
13
moving part of the machine and cause serious injuries and damage.
When working for 8 hours with a noise exceeding 90 dB, it is necessary to use
headphones.
When working in a special dangerous area, additional protections could be required
according to the conditions.
The machine is considered fire protection request fully. Using good fire-resistant
material which meet ISO 3795 standard, combustion rate is not over 200 mm/min.
Meanwhile, the machine is set enough space to mount extinguisher and supplied
extinguisher operating manual in order to prevent fire accident.
2.3.3 ENTER AND LEAVE THE MACHINE
Use the appropriate footplates and handles showed in the following picture while entering and
leaving the machine.。
Enter and leave the machine only when the machine is not moving unless it is in
emergency.
Never hold on the joysticks.
Use always the appropriate handles while entering and leaving the machine.
Always be carefully while entering and leaving the machine. Keep your body balance
during the whole processes of entering and leaving the machine.
Before enter and leave the machine, make sure the footplate and handles are not covered
with oil, grease, ice or other slippery matter. In case it happens, clean the slippery matter
carefully immediately.
Take great care in case the machine is wet. It could be very slippery.
To Next Page
Loading...
