SWL2820 Operator’s Manual
51
4.13.2 SECURING THE MACHINE
After move the machine on the transporting vehicle, to ensure the safety during transportation,
the steps following must be carried out to secure the machine.
1) Lower the bucket to the ground and let its back on the ground, see the figure
below.
2) Raise the safety bar, stop the engine and remove the key from the ignition
switch.
3) Put wedges under the wheels.
4) Use chain or cable to fix through the anchorage point.
4.13.3 UNLOADING THE MACHINE
Always follow with the safety regulations when unloading the machine from the transporting
vehicles. Any neglect on the regulations may cause serious accidents.
Follow the following steps to unload the machine from the transporting vehicles:
1) Park the transporting vehicle on a firm and level surface and apply the
braking system. Position wedges under the wheel to secure the vehicle.
2) Lock the ramps on the vehicle. The maximum ramp inclination is 15. The
ramps must be parallel.
3) Move the machine on the ramps. Keep the empty bucket forwards and the
moving direction must be parallel with the ramps.
4) Move slowly the machine from the vehicle. Do not change the moving
direction on the ramps
.
4.14 LIFTING THE MACHINE
Before lifting the machine, make sure nobody can approach the lifting area. While
lifting the machine, make sure nobody is under the machine and vicinal area.
The operator must leave the machine before lifting.
Only use homologated eyebolts and sufficient cables.
To Next Page
Loading...
