SWL2820 Operator’s Manual
43
After the coolant temperature reaches 60C, lower the restrain bar and slowly operate all
working equipment cylinders for a while.
During warming up process, check if there is any abnormal noises or vibration s. If there
is, settle the problem before working.
4.5 STOPPING THE ENGINE
If the engine is stopped abruptly, the service life may be reduced considerably. Do
not stop the engine abruptly except in an emergency.
Stop the engine as follows:
1) Run the engine at low idling for approximate 5 minutes so that the engine
cools down gradually.
2) Turn the ignition key to OFF position to stop the engine.
3) Remove the ignition key from the switch.
4.6 MACHINE MOVEMENT
Before you begin to move the machine make sure you understand all the control functions and also
all
the safety regulation. A wrong use of the machine could result fatal for the
operator or the machine.
When moving off, check the route area is safe and sound the horn before moving. If
necessary, clear all personnel and obstacles from the machine and the path.
Never carry out abrupt movements, since it could result dangerous for the security
of the operator and the machine.
Be extremely careful with curves. Slow down while running in a curve. Do not
change the direction when the machine is at high speed.
Avoid performing the working equipments when the machine is running at high
speed.
Position the rear view mirrors suitable for you before moving machine. Be
extremely careful while moving machine reversely.
To Next Page
Loading...
