3 Installation
15
Installation
Proceed as follows to install the Solar Inverter:
1. Hold the wall bracket at the point at which you
want to attach the Solar Inverter and mark the
mounting holes.
2. Drill the holes with a 10 mm dia. drill bit. A drill-
ing template with exact dimensioning can be
found in the appendix.
3. Install the wall bracket with corresponding
screws and dowels depending on the surface
condition.
4. Unscrew the locking screw of the Solar Inverter
at the lower left with an Allen key
5. Hook the Solar Inverter into the cut-outs of the
installation frame at the top on both sides.
6. Secure the Solar Inverter by tightening the lock-
ing screw.
To Next Page
Loading...
