Sunways NT 2500 - Active Alerting; General Information

7 Sunways Browser
72
· During the SMTP test an e-mail is sent to the
e-mail address stored in the monitoring system
(active alerting). Before starting the test check
whether a valid e-mail address is stored under
active alerting.
· If no login is set up on the configured SMTP
server, the password field must be left empty.
The login field is entered as the sender address
for the e-mail. If no login is specified, the Solar
Inverter sends the e-mail as
nt-inverter@sunways.de
Click «Send» to save the settings in the Solar
Inverter.
Click «Read» to display the current Solar Inverter
settings.
7.8 Active alerting
General information
With active alerting you can receive status mes-
sages (errors and warnings) for your solar system
by e-mail. If a status message was active for longer
than 15 minutes or occurred 5 times in one day, you
will receive an e-mail at the next full hour under the
e-mail address stored in the Solar Inverter.
The master sends the status messages of all Solar
Inverters if they are CAN-networked.
Requirements:
· The master must be connected to the Internet via
a network or modem.
· When dialling in via modem, the correct dial-up
settings must be stored (see Internet dial-up via
modem).
· Correct e-mail settings must be stored in the
Sunways Browser (see «Email settings»).