Supermicro 5018D-FN4T - Page 59

Chapter 5: Advanced Motherboard Setup
5-17
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Setting Denition
Pins 1-2 Enabled
Pins 2-3 Disabled
PCI Slot SMB Enable (JI2C1/JI2C2)
Use Jumpers I
2
C1/I
2
C2 to enable PCI
SMB (System Management Bus) sup-
port to improve system management
for the onboard PCI-E slot. See the
table on the right for jumper settings.
Watch Dog Timer Enable
Watch Dog (JWD1) is a system moni-
tor that can be used to enter LAN by-
pass default settings, reset the system
or enter NMI when the Timer expires.
Close pins 1-2 to reset the system if
an application hangs. Close pins 2-3
to generate a non-maskable interrupt
signal for the application that hangs.
Open all pins to enter LAN pair default
mode only. See the table on the right
for jumper settings. Watch Dog may
be enabled in the BIOS Setup. The
default timer is around 5 minutes.
Watch Dog
Jumper Settings
Setting Denition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open LAN pairs set to default
mode without reset
or NMI
PCI Slot_SMB Enable
Jumper Settings
Pin# Denition
1-2 Enabled
2-3 Disabled (Default)
LAN Ports Enable/Disable
Jumper JPL1 enables or disables
Ethernet LAN ports on the mother-
board. See the table on the right for
jumper settings. The default setting
is enabled.
GbE LAN Enable
Jumper Settings
Pin# Denition
1-2 Enabled (Default)
2-3 Disabled