15
Chapter 1: Introduction
Quick Reference
Jumper Description Default Setting
UID SW Unit ID switch (push-button toggle switch ON/OFF)
JBT1 Clear CMOS Open (Normal)
JPB1 BMC Enable/Disable Pins 1-2: (Enabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JDBG1 Debug mode control Pins 1-2: Normal mode
JWD1 Watch Dog control Pins 1-2 (Reset)
Connector Description
Battery (BT1) Onboard CMOS battery
COM 1 Front panel COM port #1
FAN 3/4 System cooling fan headers
IPMI_LAN Dedicated IPMI LAN port
JF1 Front control panel
JF2 PCI-E 3.0 x4 slot supported by CPU2
JSD1 SATA DOM power connector
JSDCARD1 Micro SD Card slot
JTPM1 Trusted Platform Module (TPM)/Port 80 connector
SIOM PCI-E 3.0 x16 slot for proprietary add-on module supported by CPU1
SXB1 PCI-E 3.0 x4 slot supported by CPU2 and SATA connections (SATA0~5) by CPU1
SXB2 PCI-E 3.0 x24 slot supported by CPU2
SXB3 PCI-E 3.0 x16 left hand riser slot supported by CPU1
SXB4 PCI-E 3.0 x16 right hand riser slot supported by CPU1
SATA6 SATA DOM with power-pin connector
J2 M.2 connector PCI-E 3.0 x4 supported by CPU1 and SATA7 connection
USB 0/1 (3.0) Back panel USB 3.0 ports
USB3 (2.0) Internal USB 2.0 port
VGA Back panel VGA port
LED Description Status
UID LED1 Rear unit ID LED
BMC_HB LED2 BMC Heartbeat LED Green: Blinking (BMC normal), Green: Fast blinking (BMC initializing)
PWR_OK LED3 Power OK LED Green: System power OK
Notes:
• " " indicates the location of Pin 1.
• Jumpers/LED indicators not indicated are used for internal testing only.
To Next Page
Loading...
