Supermicro A+ Server 2123BT-HTR - Page 72

A+ Server AS -2123BT-Hxxx User's Manual
72
transmission speed may be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control

󰀨      󰀨
󰀨
options are None,󰀨
Data Bits
Parity
Stop Bits
PCI-E/PCI/PnP Conguration

PCI Bus Driver Version
Above 4G Decoding
This setting Enables or Disables 64-bit capable devices ability to be decoded in above 4G
address space (only if the system supports 64-bit PCI decoding).
SR-IOV Support
If the system has SR-IOV capable PCI-E devices, this setting will Enable or Disable the
Single Root IO Virtualization Support for the system.
PCI-E Spread Spectrum
Use this setting to Enable or Disable PCI-E Spread Spectrum for your system.
Target Link Speed
If supported by hardware and set to Force to x.S GT/S (x being a value of 2.5, 5.0 or 8.0) for
Downstream Ports, this sets an upper limit on Link Operational Speed by restricting the values
advertised by the UPstream component in its training sequences. When Auto is selected,
the HW initialized data will be used.
VGA Priority
󰀨 Onboard
󰀨
NVMe Firmware Source
            
Vendor Dened Firmware.