BIOS Manual
5-14
Hard Disk Power Down Mode
This option specifies the power conserving state that the hard disk drive
enters after the specified period of hard drive inactivity has expired. The
settings are
Disabled
,
Standby
, or
Suspend
.
Note: The Optimal
default setting for this option is Suspend and the Fail-Safe
default setting is Disabled
.
Hard Disk Timeout (Minutes)
This option specifies the length of a period of hard disk drive inactivity. When
this length of time expires, the computer enters power-conserving state
specified in the Hard Disk Power Down Mode option. The settings are
Disabled
and
1 Min through 15 Min in 1 minute intervals
.
Power Saving Type
The settings for this option are
Sleep, Stop Clock or Deep Sleep
.
Standby/Suspend Timer Unit
This allows you to set the standby timeout and suspend timeout timer unit.
The settings are
32 secs
,
4 msecs
,
4 min
or
4 secs
.
Standby Timeout
This option specifies the length of a period of system inactivity while in full
power on state. When this length of time expires, the computer enters
standby power state. The settings are
Disabled
and
4 Min through 508 Min
in 4 minute intervals
.
Suspend Timeout (Minutes)
This option specifies the length of a period of system inactivity while in
standby state. When this length of time expires, the computer enters
suspend power state. The settings are
Disabled
and
4 Min through 508 Min
in 4 minute intervals
.
Slow Clock Ratio
The value of the slow clock ratio indicates the percentage of time the
STPCLK# signal is asserted while in the thermal throttle mode. The settings
are
Disabled, 0-12
.
5%
, 12.5-
25%
, 25-
37
.
5%
,
37
.
5-50%
,
50
-
62
.
5%
,
62
.
5-75%
,
or
75-87.5%
.
Display Activity
This option specifies if AMIBIOS is to monitor display activity for power
conservation purposes. When this option is set to
Monitor
and there is no
To Next Page
Loading...
