2-12
SUPER P6DBS/P6DBE/P6DBU/P6SBU/P6SBS/P6SBA/P6SBM Manual
Chassis Intrusion
The Chassis Intrusion Detector is
located on JL1. See the board lay-
outs in Chapter 1 and the PC Health
Monitor section (page 1-22) for
more information. See Table 2-18
for pin definitions.
Pin
Number
1
2
Definition
Intrusion Input
Ground
Table 2-18
Chassis Intrusion Pin
Definitions for JL1
Open = Default, Closed = Intrusion
PCI Audio
Drive
Connectors (P6SBM, OEM option on P6SBU)
Boards with PCI Audio
Drive
have additional input jacks and connectors installed.
Three inputs, for MIC, LINE IN and LINE OUT, can be found under the game port
header at J36. Four connectors for using Audio
Drive
are located behind the
game port. These provide connections for mono sound, both large and small CD
audio player connectors (use the one that matches the size of your connector)
and an MPEG connector for use with a DVD decoder card. See the motherboard
layout on page 1-17 for locations.
SLED (SCSI LED) Indicator
The SLED connector is used to pro-
vide an LED indication of SCSI activ-
ity. Refer to Table 2-19 for connect-
ing the SCSI LED.
Pin
Number
1
2
3
4
Definition
Positive
Negative
Negative
Positive
Table 2-19
SLED Pin Definitions
JPWAKE (P6SBM only)
The JPWAKE jumper is used in con-
junction with the Keyboard Wake-Up
function in BIOS (see page 5-19).
Enable both the jumper and the
BIOS setting to allow the system to
be woken up by depressing a key on
the keyboard. See Table 2-20 for
jumper settings.
Jumper
Position
1-2
2-3
Definition
Disabled
Enabled
Table 2-20
JPWAKE Pin Definitions
To Next Page
Loading...
