Chapter 5: Running Setup
5-19
H/W Monitor In6 (-5V)
CPU1 Fan
CPU2 Fan
Thermal Control Fan
The above features are for PC Health Monitoring. The motherboards with
W83781D have seven on-board voltage monitors for the CPU core, CPU I/O,
+3.3V, +5V, -5V, +12V, and -12V, and three fan status monitors.
Power Loss Control
This option determines how the system will respond when power is lost and
then comes back. The settings are
Always Off
,
Always On
and
Previous
,
which returns the system to the state it was in before the power loss.
Keyboard Wake-Up Function
Use this option to determine which key will wake-up the system when
depressed. The settings are
Disabled
,
CTRL F1
and
Space
(spacebar).
On-Board FDC
This option enables the FDC (Floppy Drive Controller) on the motherboard.
The settings are
Auto
(AMIBIOS automatically determines if the floppy
controller should be enabled),
Disabled
, or
Enabled
.
On-Board Serial Port 1
This option specifies the base I/O port address of serial port 1. The settings
are
Auto
(AMIBIOS automatically determines the correct base I/O port
address),
Disabled
,
3F8h/
COM1,
2F8h/COM2
,
3E8h/COM3
or
2E8h/COM4
.
On-Board Serial Port 2
This option specifies the base I/O port address of serial port 2. The settings
are
Auto
(AMIBIOS automatically determines the correct base I/O port
address),
Disabled
,
3F8h/COM1
,
2F8h/COM2
,
3E8h/COM3
or
2E8h/COM4
.
Serial Port 2 Mode
The settings for this option are
Normal, IrDA
or
ASK IR
. When set to
IrDA,
the IR Duplex Mode becomes available and can be set to either Half or Full.
When set to
ASK IR,
the IrDA Protocol becomes available and can be set to
1.6 us or 3/16.
On-Board Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are
Auto
(AMIBIOS automatically determines the
correct base I/O port address),
Disabled
,
378
,
278
or
3BC
.
To Next Page
Loading...
