Supermicro SuperServer 1019C-HTN2 - Page 82

SuperServer1019C-HTN2 User's Manual
82

boot. The options are Disabled and PXE.
Onboard LAN2 Option ROM

boot. The options are Disabled, PXE, and iSCSI.
Network Stack

Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If the feature above is set to Enabled, the next seven features will be available for
conguration:
Ipv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and Enabled.
Ipv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
Ipv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and Enabled.
Ipv6 HTTP Support
Select Enabled to enable IPv6 HTTP boot support. The options are Disabled and Enabled.
IPSECCerticate
󰀨
a secure connection for remote computers using a secure tunnel. The options are Enabled
and Disabled.
PXE boot wait time
Use this feature to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is 0.
Media detect count
Use this option to specify the number of times media will be checked. Press "+" or "-" on your
keyboard to change the value. The default setting is 1.
HTTPBOOTConguration
HTTPBOOTConguration