Supermicro SuperStorage Server 2028R-NR48N - Installing the Outer Rails on the Rack

2-7
Installing the Outer Rails on the Rack
Installing the Outer Rails
1. Conrm that the left and right outer rails have been correctly identied.
2. Release the small locking lever on the inside of the middle rail and push the
middle rail back into the outer rail.
3. Insert the square pins at the front of the outer rail into the square holes on the
front of the rack. Push until the latch snaps into place.
4. The outer rail is actually two pieces that slide to lengthen. Pull out the rear of
the outer rail, adjusting the length until the square pin assembly passes, then
ts against the back of the rear post. Be careful to keep the rail level.
5. Insert the square pins at the rear of the outer rail into the square holes on the
rear of the rack. Push until the latch snaps into place.
6. Repeat for the other outer rail.
Figure 2-4. Installing the Outer Rails
Stability hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the oor before you slide the unit out for servicing.
Failure to stabilize the rack can cause the rack to tip over.
Locking Lever on
Middle Rail