Chapter 5: Advanced Serverboard Setup
5-7
5-4 Installing Memory
Memory Support
The X10DSC+ supports Load Reduced (LRDIMM) or Registered (RDIMM) ECC
DDR4-2400/2133/1866/1600 memory. For best performance, install pairs of memory
modules of the same type and speed. All channels will run at the fastest common
frequency.
For optimal memory performance, install a pair (or pairs) of memory modules of the
same type and speed (see the Memory Installation Table below).
Note: Memory speed support depends on the CPUs installed in the motherboard.
For the latest memory updates, please refer to the product page on our website.
DIMM Installation
Caution: Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Installing Memory Modules
Insert the desired number of DIMMs into the memory slots starting with DIMM slot
#P1-DIMMA1.
1. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
Insert each DIMM module vertically into its slot. Pay attention to the key along
the bottom of the module to avoid installing incorrectly (Figure 5-2).
2. Gently press down on the DIMM module until it snaps into place in the slot. Press
the release tabs to the locking positions to secure the DIMM module into the slot.
Figure 5-2. DIMM Installation
Socket Key
Release Tab
Release Tab
To Next Page
Loading...
