6-1
Chapter 6: Chassis Setup and Maintenance
Chapter 6
Chassis Setup and Maintenance
6-1 Overview
This chapter covers the steps required to install components and perform
maintenance on the chassis. The only tool required is a Phillips screwdriver.
Review the warnings and precautions listed in the manual before setting up or
servicing this chassis. These include information in Chapter 2: Warning Statements
for AC Systems and the warning/precautions listed in the setup instructions.
Figure 6-2. Rear View
Hot-Swap HDDs
Control Panel
Figure 6-1. Front View
PCI Slots
Power Supplies
I/O Ports
Hard Drives (2)
To Next Page
Loading...
