C-4
X10QBi Motherboard User’s Manual
progress of BIOS recovery as shown in the screen below.
Note: Do not interrupt the process of BIOS ashing until it is com-
pleted.
6. After the process of BIOS recovery is completed, press any key to reboot the
system.
7. Using a different system, extract the BIOS package into a bootable USB ash
drive.
8. When a DOS prompt appears, enter FLASH.BAT BIOSname.### at the
prompt.
Note: Do not interrupt this process until BIOS ashing is completed.
9. After seeing the message that BIOS update is completed, unplug the AC
power cable from the power supply to clear the CMOS, and then plug the AC
power cable in the power supply again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load default settings.
12. After loading default settings, press <F4> to save the settings and exit the
BIOS Setup utility.
5. When the screen as shown above displays, using the arrow key, select the
item "Proceed with ash update" and press the <Enter> key. You will see the
To Next Page
Loading...
