Supermicro x10qbi - Serial Ports (COM1: on the Baseboard, COM2: on the I;O Module); Video Connectors (on the I;O Module)

Chapter 2: Installation
2-21
X10QBi
Rev:1.01B
MAC CODE
BAR CODE
CPU4
CPU3
CPU1
CPU2
MAC CODE
SW1
LED28
JPB1
JPG1
JPL1
AOM-X10QBi-A/L
Rev. 1.02
SWUID1
JEDUID1
COM2
IPMI_LAN
LAN2
LAN1
VGA1
VGA2
LAN CTRL
BMC
AOM-X10QBi-A/L I/O Module
SIO Slot
C
D
A
C
B
Video Connectors (On the I/O
Module)
Two Video (VGA) ports are located
on the AOM-X10QBi-A/L I/O module.
Refer to the baseboard layout below
for the location.
A. COM1
B. COM2
C. VGA1
D. VGA2
Serial Ports (COM1: On the
Baseboard, COM2: On the I/O
Module)
A COM port header (COM1) is located
on the X10QBi baseboard to provide
front-accessible serial support. An-
other COM port is located on the AOM-
X10QBi-A/L I/O module for rear chassis
access. See the table on the right for
pin denitions.
Serial (COM) Port/Header
Pin Denitions
Pin # Denition Pin # Denition
1 DCD 6 DSR
2 RXD 7 RTS
3 TXD 8 CTS
4 DTR 9 RI
5 Ground 10 N/A
X10QBi-A Baseboard