Supermicro x10qbi - BMC Enable (on the I;O Module); VGA Enable (on the I;O Module)

2-36
X10QBi Platform User's Manual
SW1
LED28
JPB1
JPG1
JPL1
AOM-X10QBi-A/L
Rev. 1.02
SWUID1
JEDUID1
COM2
IPMI_LAN
LAN2
LAN1
VGA1
VGA2
LAN CTRL
BMC
BMC Enable (On the I/O Module)
Jumper JPB1 allows you to enable the
BMC controller on the X10QBi-A I/O
module for IPMI/KVM support. Refer to
the table on the right for jumper settings.
BMC Enable
Jumper Settings
Jumper Setting Denition
Pins 1-2 BMC Enable (Default)
Pins 2-3 Disabled
VGA Enable (On the I/O Module)
Jumper JPG1 allows the user to enable
VGA Ports 1/2 support on the I/O mod-
ule. The default setting is "1-2" to enable
the connection. Refer to the table on the
right for jumper settings.
VGA Enable
Jumper Settings
Jumper Setting Denition
1-2 Enabled (Default)
2-3 Disabled
A
A. BMC Enable
B. VGA Enable
B