Supermicro x10qbi - Memory Configuration

4-14
X10QBi Platform User’s Manual
Link L0p Enable
Select Enable for Link L0p support. The options are Disable and Enable.
Link L1 Enable
Select Enable for Link L1 support. The options are Disable and Enable.
Legacy VGA Socket
Enter the VGA socket number (from 0-7) that will be used to support legacy
VGA. The default setting is 0.
QPI Per Socket Conguration
CPU 0/CPU 1/CPU 2/CPU 3
Bus Resource Allocation Ratio
Use this feature to set the bus resource-allocation ratio (from 0-8). The default
setting is 1.
IO Resource Allocation Ratio
Use this feature to set the IO resource-allocation ratio (from 0-8). The default
setting is 1.
MMIOL Resource Allocation Ratio
Use this feature to set the Memory-Mapped IO resource-allocation ratio (from
0-8). The default setting is 1.
IIO UniPhy Disable
Select Yes to hide the entire UNIFY in L2 cache. The options are No and Yes.
Memory Conguration
This section displays the following Integrated Memory Controller (IMC) informa-
tion.
Halt On Memory Error
Use this feature to halt the system when a memory error has occurred. The
options are Disabled and Enabled.
DDR Speed
Use this feature to force a DDR3 memory module to run at a frequency other
than what is specied in the specication. The options are Auto, 1067, 1333,
1600, 1867, and 2133.