Supermicro x10qbi - 2-4 I;O Module and Memory Card Installation; Installing the AOM-X10 QBi-A;L I;O Module

Chapter 2: Installation
2-11
SW1
LED28
JPB1
JPG1
JPL1
AOM-X10QBi-A/L
Rev. 1.02
SWUID1
JEDUID1
COM2
IPMI_LAN
LAN2
LAN1
VGA1
VGA2
LAN CTRL
BMC
Installing the AOM-X10QBi-A/L I/O Module on the
Mainboard
Note: After you've installed the CPUs and heatsinks on the baseboard,
be sure to install the AOM-X10QBi-A/L I/O module card on the SIO slot
as shown on the gure below before you power on the system. Without
the I/O module being installed on the motherboard, your system cannot
be turned on.
AOM-X10QBi-A/L I/O Module
SIO Slot
2-4 I/O Module and Memory Card Installation
D
A
C
B
E
G
F
I/O Port Locations and Denitions
A. VGA1: VGA/Video Connector 1
B. LAN2: LAN Port2
C. LAN1: LAN Port1
D. (BMC) IPMI_LAN
E. UID (Unit Identier) Switch & UID LED (Blue: Unit Identied)
F. VGA2: VGA/Video Connector 2
G. COM2: COM Connection 2
1 2 3
Jumpers
1. JPL1: LAN Enable/Disable (Default: Pins 1-2: Enabled)
2. JPB1: BMC Enable/Disable (Default: Pins 1-2: Enabled)
3. JPG1: VGA Enable/Disable (Default: Pins 1-2: Enabled)
D
A
C
B
E
G
X10QBi
Rev:1.01B
MAC CODE
BAR CODE
CPU4
CPU3
CPU1
CPU2
MAC CODE