Supermicro X11DPL-i - Page 101

Chapter 4: UEFI BIOS
101
When a TPM (Trusted-Platform Module) device is detected in your machine, the following
information will be displayed.
• Security Device Support
• No Security Device Found
Security Device Support
If this feature and the TPM jumper (JPT1) on the motherboard are both enabled, the onboard
security (TPM) device will be enabled in the BIOS to enhance data integrity and system
security. Please note that the OS will not show the security device. Neither TCG EFI protocol
nor INT1A interaction will be made available for use. If you have made changes on the setting
on this feature, be sure to reboot the system for the change to take effect. The options are
Disable and Enable.
HTTP BOOT Conguration Settings
Use this feature to con gure HTTP Boot settings for your system.
HTTP Boot One Time
If this feature is set to Enabled, the system will automatically boot into the HttpBoot setting
that has been previously congured when it was powered up the  rst time. The options are
Enabled and Disabled.
Input the Description
This feature allows the user to input the description of the boot.
Boot URI
This feature allows the user to boot the system from a network connection.
Trusted Computing (Available when a TPM device is installed
and detected by the BIOS)