Supermicro X11DPL-i User Manual

28
X11DPL-i User's Manual
Attaching the Processor to the CPU/Heatsink Carrier
To properly install the CPU onto the CPU/heatsink carrier, please follow the steps below.
1. Locate Pin 1 (Notch A), Notch B, and Notch C on the CPU and locate Pin 1 (Notch A),
Notch B, and Notch C on the CPU/heatsink carrier.
2. Align Pin 1 (Notch A), Notch B, and Notch C on the CPU with the corresponding
notches on the carrier. Once they are aligned, carefully insert the CPU into the carrier
until you hear a click. Once the CPU is properly mounted onto the carrier, the CPU/
carrier assembly is made.
A
B
C
A
B
C
A
B
C
Pin 1
Align CPU Notch B
and Clip B
Align CPU Notch C
and Clip C
Align CPU Pin 1
CPU
(Upside Down)
Package Carrier
(Upside Down)
CPU Mounted on
Package Carrier
(Upside Down)
Allow Clip B to
Latch on to CPU
Allow Clip C to
Latch on to CPU
CPU Mounted on
Package Carrier
(Rightside Up)

Supermicro X11DPL-i Specifications

General

USB 2.0 ports quantity	4
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	3
Supported DIMM module capacities	64GB, 128MB
Memory voltage	1.2 V
Supported memory types	DDR4-SDRAM
Maximum internal memory	128 GB
Supported memory clock speeds	2133, 2400, 2666 MHz
RAID levels	0, 1, 5, 10
Wi-Fi	No
Ethernet LAN	Yes
Ethernet interface type	Gigabit Ethernet
System bus rate	10.4 GT/s
Processor manufacturer	Intel
Processor thermal power (max)	140 W
PCI Express x16 (Gen 3.x) slots	2
BIOS type	UEFI AMI
Motherboard chipset	Intel® C621
Motherboard form factor	ATX
Harmonized System (HS) code	84733020

Weight and Dimensions

Depth	257.8 mm
Width	306.7 mm