Supermicro X11DPL-i - Page 94

X11DPL-i User's Manual
94
Super IO Conguration
The following Super IO information will display:
• Super IO Chip AST2500
Serial Port 1 Conguration
This submenu allows the user the congure settings of Serial Port 1.
Serial Port 1
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings
This feature displays the status of a serial part specied by the user.
Change Settings
This feature species the base I/O port address and the Interrupt Request address of a
serial port specied by the user. Select Auto to allow the BIOS to automatically assign the
base I/O and IRQ address. The options for Serial Port 1 are Auto, (IO=3F8h; IRQ=4;),
(IO=2F8h; IRQ= 4;), (IO=3E8h; IRQ=4;), and (IO=2E8h; IRQ=4;).
SOL Conguration
This submenu allows the user to congure the settings of Serial Port 2.
SOL
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings
This feature displays the status of a serial part specied by the user.
Change Settings
This feature species the base I/O port address and the Interrupt Request address of a
serial port specied by the user. Select Auto to allow the BIOS to automatically assign the
base I/O and IRQ address. The options for Serial Port 2 are Auto, (IO=2F8h; IRQ=3;),
(IO=3F8h; IRQ=3;), (IO=3E8h; IRQ=3;), and (IO=2E8h; IRQ=3).
SOL Attribute
Select SOL to use COM Port 2 as a Serial Over LAN (SOL) port for console. The options
are SOL and COM.