EasyManuals Logo

Supermicro X9DRW-iF User Manual

Supermicro X9DRW-iF
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
3-1
Chapter 3: Troubleshooting
Chapter 3
Troubleshooting
3-1 Troubleshooting Procedures
Use the following procedures to troubleshoot your system. If you have followed all
of the procedures below and still need assistance, refer to the ‘Technical Support
Procedures’ and/or ‘Returning Merchandise for Service’ section(s) in this chapter.
Always disconnect the AC power cord before adding, changing or installing any
hardware components.
Before Power On
1. Make sure that there are no short circuits between the motherboard and
chassis.
2. Disconnect all ribbon/wire cables from the motherboard, including those for
the keyboard and mouse, if any.
3. Remove all add-on cards.
4. Install CPU 1 rst (making sure it is fully seated) and connect the front panel
connectors to the motherboard.
No Power
1. Make sure that there are no short circuits between the motherboard and the
chassis.
2. Make sure that the ATX power connectors are properly connected
3. Check that the 115V/230V switch on the power supply is properly set, if avail-
able.
4. Turn the power switch on and off to test the system, if applicable.
5. The battery on your motherboard may be old. Check to verify that it still sup-
plies ~3VDC. If it does not, replace it with a new one.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Supermicro X9DRW-iF and is the answer not in the manual?

Supermicro X9DRW-iF Specifications

General IconGeneral
PS/2 ports quantity0
IPMI LAN (RJ-45) portYes
USB 2.0 ports quantity4
Ethernet LAN (RJ-45) ports2
PCI Express slots version3.0
Memory voltage1.35, 1.5 V
Memory channelsDual-channel
Maximum RDIMM memory512 GB
Supported memory typesDDR3-SDRAM
Supported memory clock speeds800, 1066, 1333, 1600 MHz
Maximum UDIMM memory128 GB
Number of DIMM slots16
Supported RDIMM module capacity16GB, 1GB, 2GB, 32GB, 4GB, 8GB
Supported UDIMM module capacity1GB, 2GB, 4GB, 8GB
BIOS typeAMI
ACPI version4.0
BIOS memory size128 Mbit
RAID levels0, 1, 5, 10
Supported storage drive interfacesSATA II, SATA III
Wi-FiNo
LAN controllerIntel® I350
Ethernet interface typeGigabit Ethernet
On-board graphics card modelMatrox G200
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)10 - 35 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)8 - 90 %
Supported QPI8 GT/s
Processor socketLGA 2011 (Socket R)
Intel Xeon seriesE5-2600
Processor manufacturerIntel
Processor thermal power (max)135 W
Processor number of cores supported6, 8
Component forServer
Motherboard chipsetIntel® C602
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth330 mm
Width305 mm

Related product manuals