Supermicro X9DRW-iF - Page 92

4-16
X9DRW-3F/X9DRW-iF Motherboard User’s Manual
Onboard LAN Option ROM Select
Select iSCSI to use the iSCSI Option ROM to boot the computer using a network
device. Select PXE (Preboot Execution Environment) to use an PXE Option ROM
to boot the computer using a network device. The options are iSCSI and PXE.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 Option ROM/LAN2 Option ROM. This
is to boot the computer using a network device. The default setting for LAN1 Op-
tion ROM is Enabled, and the default setting for LAN2 Option ROM is Disabled.
VGA Priority
This feature allows the user to select the graphics adapter to be used as the primary
boot device. The options are Onboard, and Offboard.
Network Stack
Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unied
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.
SuperIOConguration
Super IO Chip: This item displays the Super IO chip used in the motherboard.
SerialPort1Conguration
Serial Port
Select Enabled to enable a serial port specied by the user. The options are En-
abled and Disabled.
Device Settings
This feature indicates whether or not a reset is required for a serial port specied.
Change Settings
This option species the base I/O port address and the Interrupt Request address
of Serial Port 1 and Serial Port 2. The options for Serial Port 1 are: Auto, IO=3F8h;
IRQ=4; IO=3F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; IO=2F8h; IRQ=3, 4, 5, 6, 7, 9,
10, 11, 12; IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; and IO=2E8h; IRQ=3, 4, 5,
6, 7, 9, 10, 11, 12.