Chapter 2: Installation
2-5
X10DAi/DAC/DAX
Rev. 1.01
SAS CODE
BIOS
LICENSE
MAC CODE
BAR CODE
Location of Mounting Holes
There are nine (9) mounting holes on this motherboard indicated by the arrows.
2-3 Motherboard Installation
All motherboards have standard mounting holes to t different types of chassis.
Make sure that the locations of all the mounting holes for both motherboard and
chassis match. Although a chassis may have both plastic and metal mounting fas-
teners, metal ones are highly recommended because they ground the motherboard
to the chassis. Make sure that the metal standoffs click in or are screwed in tightly.
Then use a screwdriver to secure the motherboard onto the motherboard tray.
Tools Needed
•Phillips Screwdriver
•Pan head screws (9 pieces)
•Standoffs (9 pieces, if needed)
Warning: 1) To avoid damaging the motherboard and its components, please do
not use a force greater than 8 lb/inch on each mounting screw during motherboard
installation. 2) Some components are very close to the mounting holes. Please take
precautionary measures to prevent damage to these components when installing the
motherboard to the chassis.
To Next Page
Loading...
Need help?
General
