Chapter 4: AMI BIOS
4-37
When SEL is Full
This feature allows the user to determine what the BIOS should do when the sys-
tem event log is full. Select Erase Immediately to erase all events in the log when
the system event log is full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for
the changes to take effect.
BMC Network Conguration
The following items will be displayed:
IPMI LAN Selection
This item displays the IPMI LAN setting. The default setting is Failover.
IPMI Network Link Status
This item displays the IPMI Network Link status. The default setting is Shared LAN.
Update IPMI LAN Conguration
Select Yes for the BIOS to implement all IP/MAC address changes at the next
system boot. The options are No and Yes
Conguration Address Source
Use this item to select the source of the IP address for this computer. If Static is
selected, you will need to know the IP address of this computer and enter it to the
system manually in the eld. If DHCP is selected, the BIOS will search for a DHCP
(Dynamic Host Conguration Protocol) server in the network that is attached to
and request the next available IP address for this computer. The options are DHCP
and Static.
The following items are assigned IP addresses automatically if DHCP is selected,
or they can be congured manually if Static is selected.
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each
three-digit number separated by dots should not exceed 255.
Station MAC Address
This item displays the Station MAC address for this computer. Mac addresses are
6 two-digit hexadecimal numbers.
To Next Page
Loading...
Need help?
General
