Supero X10SRL-F User Manual

4-22
X10SRL-F User’s Manual

sSATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence
of the SATA devices that are supported by the SCU controller and displays the
following items:
sSATA Controller
This item enables or disables the onboard SATA controller supported by the Intel
SCU chip. The options are Enabled and Disabled.
Congure sSATA as
Select IDE to congure an sSATA drive specied by the user as an IDE drive. Select
AHCI to congure an sSATA drive specied by the user as an AHCI drive. Select
RAID to congure an sSATA drive specied by the user as a RAID drive. The op-
tions are IDE, AHCI, and RAID.
*If the item above "Congure sSATA as" is set to AHCI, the following items
will display:
Support Aggressive Link Power Management
When this item is set to Enabled, the sSATA AHCI controller manages the power
usage of the sSATA link. The controller will put the link in a low power mode
during extended periods of I/O inactivity, and will return the link to an active state
when I/O activity resumes. The options are Enabled and Disabled.
sSATA Port 0~ Port 3
This item displays the information detected on the installed sSATA drives on the
particular sSATA port.
•Model number of drive and capacity
•Software Preserve Support
sSATA Port 0~ Port 3
Select Enabled to enable an sSATA port specied by the user. The options are
Disabled and Enabled.
sSATA Port 0 ~ Port 3 Hot Plug
This feature designates the sSATA port specied for hot plugging. Set this item
to Enabled for hot-plugging support, which will allow the user to replace an
sSATA disk drive without shutting down the system. The options are Enabled
and Disabled.

Supero X10SRL-F Specifications

General

Brand	Supero
Model	X10SRL-F
Category	Motherboard
Language	English