21
Recording on/off – Indicates that the Xpert unit has turned recording on
(Recording on), or recording off(Recording off)
GPRS connect failure - Indicates that GPRS services may not currently be available (a
given cell tower may support GSM/SMS services but not GPRS), or that there’s
something wrong with the APN settings, the account, the provider, etc.
Shoulder tap failure - If GPRS is unable to perform a shoulder tap that’s been
requested by the user using SMS, the command line, or by ringing the cell modem
(CSDShoulderTap=Yes), then it should send an “STAP failed (could not
connect)” SMS notification message. The shoulder tap requires making a TCP/IP
connection to the IP and port specified by the command or the primary IP and
command port if other settings were not supplied.
NotifyList
Allows to user to choose what phone numbers get the SMS notification for
SMSNotifyEnable’s events. Separate phone numbers with a comma “,”.
SetupPassword and DataPassword
These two properties specify authorization codes used to validate incoming command
messages. SetupPassword specifies the authorization code for “setup-level” access, while
DataPassword specifies the authorization code for “data-level” access.
Incoming command messages have setup-level access by default. When the
SetupPassword property contains an authorization string, any and all incoming messages
that normally require setup-level access to be processed must prefix the command with
the authorization code. For example, to command the station to reboot with an
authorization code of “MyAuthCode”, the incoming message content would be
“MyAuthCode reboot”.
SetupUserList and DataUserList
These two properties are authorization settings that require the phone number stated in
the Authlist to be used to validate incoming command messages. Both SetupUserList and
DataUserList are only enabled in addition to the SetupPassword and DataPassword being
enabled.
A better explanation about how it’s used is if the SetupUserList property specifies a
phone number, while SetupPassword is blank, then a user from any phone number can
send a setup command with no code, and the command will be processed. However if
SetupUserList property is blank, while SetupPassword has a code, then the user must
have the code, regardless of his phone number.
For example if he or she wants to send the reboot command he or she needs to use the
SetupPassword string, as well send the SMS message with command from the phone
number listed in SetupUserList.
SMS command = Reboot
SetupPassword = sutron
To Next Page
