Sutron 9210 - Tagging Data with EzSetup

25
TxContent, DataInterval, DataTime, NumValues
These properties define what data to include in the transmission. See the following table
for details:
Tx Content
Description of data to transmit
All
All the data logged for the output since the
last transmission will be transmitted
Individual
Individual values logged for the output since
the last transmission will be transmitted.
Data Interval
The time interval between readings. For
example, “01:00:00” means “hourly data”
Data Time
The time, or offset into the interval, of the
data to include. For example, “00:15:00”
means “include data measured on a 15 minute
offset”
Num Values
Number of values for each data item to
include in the transmission
Last
Only the last value measured will be
transmitted
Exclude
Do not transmit this output
Sequence
This property determines the order of the data item within the transmission.
Right Digits
This property determines the number of right digits to include in the transmission.These
properties determine what data is included in transmissions, and its sequence in the
transmission (if applicable to the selected format). The value of Tx Content can be All,
Individual, Last, or Exclude as described below. Setting Tx Content will enable or
disable other properties:
Note: When Pseudobinary B (an interleaved format) is the selected format, the user
defines a Num Values setting for all outputs in the GPRS Transmission Settings Dialog,
and the meaning of the Tx Content property on each output changes: A Tx Content value
of “Last” no longer means just the last value, but the last Num Values values. A Tx
Content value of “All” no longer means all values since last transmission, but all values
up to Num Values.
Tagging Data with EzSetup
Tagging data for GPRS transmission in EzSetup requires placing a check next to the
GPRS button and then pressing the GPRS button to select the properties.