7
INSTALLATION
This section describes the installation and configuration of the GPRS.sll library.
Installation
GPRS.sll is required for GPRS operation. To install the library, copy the GPRS.sll file to
the “\Flash Disk” subdirectory of your Xpert using Xterm. For more information on
performing this file transfer, please refer to chapter 6 of the Xpert or 9210 user manual.
Once the files have been transferred, reboot the Xpert. The libraries will load
automatically after the Xpert reboots.
To uninstall the libraries, use Xterm to delete the files from the Flash Disk subdirectory.
This can only be done when the Xpert application is not running (select “Exit App” from
the Status tab).
In order for the libraries to load and operate correctly, the versions of the files must be the
same as the version of the application loaded into the Xpert. This is usually not a concern
because the same versions of the slls and application are typically packaged together.
Should the need arise to verify that the versions are the same; the version of a sll as it
resides on the PC can be determined by looking at the file’s properties (right-click on the
file and select the “Version” tab). The version of the Xpert application is given by the
application itself, at the top of the About dialog, which is accessed from the Status tab.
To Next Page
Loading...
