33
Selftimed Test Transmission
The Selftimed Test Transmission screen is used to verify GPRS messaging. An ASCII
message is sent to the server using the “session type 0” header.
Figure 18: Selftimed Test Transmission
The fields in the Selftimed Test Transmission Dialog are defined as follows:
Selftimed Test Message
Enter a message to send.
IP
Enter the IP address or URL of the server that is to receive the message.
Port
TCP/IP port number of the service handling Selftimed messages on the server
Select test transmission
Select Selftimed
SSP Test Transmission
The SSP Test Transmission screen us used to verify SSP messaging over GPRS, by
transmitting an SSP mail message to the specified server (or RTU) and verifying that the
message was acknowledged.
To Next Page
Loading...
