RV125K7 (’07-MODEL) 35
SELF-DIAGNOSTIC PROCEDURES
NOTE:
* Do not disconnect the coupler from ECM, battery cable from
battery, ECM ground wire from engine or main fuse before
confirming the DTC (Diagnostic Trouble Code) stored in mem-
ory. Such disconnection will erase the memorized information
in ECM memory.
* DTC stored in ECM memory can be checked by the special
tool.
* Before checking DTC, read SELF-DIAGNOSIS FUNCTION
“USER MODE and DEALER MODE” (Page 30 and 31)
carefully to have good understanding as to what functions are
available and how to use it.
* Be sure to read “PRECAUTIONS IN SERVICING” (Page 13)
before inspection and observe what is written there.
• Remove the right frame cover. (RV125K3 5-3)
• Connect the special tool to the dealer mode coupler at the wir-
ing harness.
• Turn the special tool’s switch ON and check the malfunction
code to determine the malfunction part.
09930-82720: Mode select switch
To Next Page