Suzuki 125 - Cable and Hose Routing

94 RV125K7 (’07-MODEL)
CABLE AND HOSE ROUTING
CABLE ROUTING
1 Throttle cable No.1
*1
Pass the throttle cables in front of
the brake hose.
*4 Set the clamp as shown.
2 Throttle cable No.2 *5 Clamp the harness only.
3 Wiring harness
*2
Pass the throttle cables above
the wiring harness.
*6
Set the upper end of clutch cable
protector to the lower end of clamp.
4 Clutch cable
5 Harness *3
Set the thread part of throttle
cables to lowest position.
*7 Cotter pin must face upper side.
0 mm
0 mm
*3
*5
*6
*4
*7
*1
*2