RV125K7 (’07-MODEL) 81
TO SENSOR REMOVAL AND INSTALLATION
• Remove the right frame cover. (RV125K3 5-3)
• Remove the rear fender bolts.
• Remove the TO sensor.
• Install the TO sensor in the reverse order of removal.
NOTE:
When installing the TO sensor, the arrow mark A must be
pointed upward.
HO2 SENSOR INSPECTION
The heated oxygen sensor is installed in the exhaust pipe.
(Page 75)
HO2 SENSOR REMOVAL AND
INSTALLATION
• Remove the seat. (RV125K3 5-3)
• Remove the right frame cover. (RV125K3 5-3)
• Disconnect the coupler 1.
To Next Page