RV125K7 (’07-MODEL) 39
USE OF SDS DIAGNOSTIC PROCEDURES
NOTE:
* Do not disconnect the coupler from ECM, battery cable from
battery, ECM ground wire from engine or main fuse before
confirming the DTC (Diagnostic Trouble Code) stored in mem-
ory. Such disconnection will erase the memorized information
in ECM memory.
* DTC stored in ECM memory can be checked by SDS.
* Be sure to read “PRECAUTIONS IN SERVICING” (Page 13)
before inspection and observe what is written there.
• Remove the right frame cover. (RV125K3 5-3)
• Set up the SDS tool. (Refer to the SDS operation manual for
further details.)
• Read the DTC (Diagnostic Trouble Code) and show data
when trouble (displaying data at the time of DTC) according to
instructions displayed on SDS.
• SDS is not only used for detecting DTC but also for reproduc-
ing and checking on screen the failure condition as described
by customers using the trigger.
• How to use trigger. (Refer to the SDS operation manual for
further details.)
09904-41010: SDS set tool
99565-01010-009: CD-ROM Ver. 9
To Next Page