RV125K7 (’07-MODEL) 69
“32” (P0201) FUEL INJECTOR CIRCUIT MALFUNCTION
NOTE:
When the ignition switch is turned to ON position, the fuel injec-
tor starts to operate approx. 2 sec. as purge operation (initial
operation)
INSPECTION
Step 1
1) Turn the ignition switch OFF.
2) Check the fuel injector coupler 1 for loose or poor contacts.
If OK, then measure the fuel injector resistance.
3) Disconnect the fuel injector coupler.
4) Measure the fuel injector resistance.
Fuel injector resistance: Approx. 1.9 Ω at 20 °C
(Terminal – Terminal)
DETECTED CONDITION POSSIBLE CAUSE
When the fuel injector current in each detection is
low for consecutive10 times or more.
• Fuel injector circuit open or short
• Fuel injector malfunction
• ECM malfunction
Fuel injector
Fuel injector
R/W
Fuel injector
ECM
W/Bl
1
1
To Next Page