38 RV125K7 (’07-MODEL)
*40
C40 code has no first digit display. For this reason, the interval A between the displays as shown below is
longer than the others.
SELF-DIAGNOSIS RESET PROCEDURE
• After repairing the trouble, turn OFF the ignition switch and
turn ON again.
• If the FI indicator light turns OFF, the malfunction is cleared.
• Disconnect the special tool from the dealer mode coupler.
NOTE:
* Even though the Current DTC is cleared, Past DTC (previous
malfunction history code) still remains stored in the ECM.
Therefore, erase the Past DTC memorized in the ECM using
SDS.
* DTC is memorized in the ECM also when the wire coupler of
any sensor is disconnected. Therefore, when a wire coupler
has been disconnected at the time of diagnosis, erase the
stored DTC (Past DTC) using SDS.
4
4
0
0
4.0 sec.
1.0 sec.
FI
To Next Page