40 RV125K7 (’07-MODEL)
USE OF SDS DIAGNOSIS RESET PROCEDURE
• After repairing the trouble, turn OFF the ignition switch and
turn ON again.
• Click the DTC inspection button 1.
• Check the DTC.
• The previous malfunction history code (Past DTC) still
remains stored in the ECM. Therefore, erase the history code
memorized in the ECM using SDS tool.
NOTE:
The malfunction code is memorized in the ECM also when the
wire coupler of any sensor is disconnected. Therefore, when a
wire coupler has been disconnected at the time of diagnosis,
erase the stored malfunction history code using SDS.
• Click “Clear” 2 to delete history code (Past DTC).
• Follow the displayed instructions.
• Check that both “Current DTC” 3 and “Past DTC” 4 are
deleted (NIL).
To Next Page