RV125K7 (’07-MODEL) 7
MAINTENANCE AND TUNE-UP
PROCEDURES
This section describes the servicing procedures for each Peri-
odic Maintenance item which differ from those of the RV125K6
(’06-MODEL).
For details other than the following items, refer to the RV125
Service Manual.
THROTTLE CABLE PLAY
Adjust the throttle cable play A with the following three steps.
First step:
• Loosen the lock-nut 2 of the throttle returning cable 1.
• Turn in the adjuster 3 fully.
Second step:
• Loosen the lock-nut 5 of the throttle pulling cable 4.
• Turn the adjuster 6 in or out until the throttle cable play A
should be 2.0 – 4.0 mm at the throttle grip.
• Tighten the lock-nut 5 while holding the adjuster 6.
Third step:
• While holding the throttle grip at the fully closed position,
slowly turn out the adjuster 3 of the throttle returning cable 1
to feel resistance.
• Tighten the lock-nut 2 while holding the adjuster 3.
Throttle cable play A: 2.0 – 4.0 mm
Inspect initially at 1 000 km (5 months) and every 4 000
km (20 months) thereafter.
After the adjustment is completed, check that handle-
bars movement does not raise the engine idle speed
and that the throttle grip returns smoothly and auto-
matically.
To Next Page
Loading...
